Before starting make sure your hands are clean.
Taking the Micro RCA apart.
Micro RCA comes with two build screws on each side, one side is the plus terminal of the deck and the other is minus terminal. This provides more possibility for you to install your coil exactly and comfortably.
The kit includes a small airflow tip that can be placed onto the central airhole of the Rebuildable Clapton Atomizer deck. It is designed for throat hit vape by reducing the airflow.
Installing the pre-wrapped coil.
Place the coil (it can be Clapton coil or others) between the screws and wrap the ends around them and tighten up.
Attention: The coil has to be wrapped with one end at the plus terminal, with the other end at the minus terminal.
Positioning and cutting the exceeding ends of wire off.
Make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
Then cut the exceeding ends of wire off.
Cutting a strip of cotton and make sure it's not too much and not too less.
Inserting the cotton, and placing it in the middle.
Cutting the cotton at an angle and make sure it's not too short and not too long.
Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked
periodically to ensure the resistance remains the same.